User manual
Table Of Contents
- Important Safety Information
- Introduction
- Installation
- Operation
- Turn the Power On
- Turn the Power Off
- Manage Firmware
- Select a Video Input
- Select an Audio Input
- Adjust the Outputs
- Adjust the Audio Processing Mode
- Adjust the Auto Preset Select
- Adjust Dolby True HD Dynamic Range Compression
- Adjust Dolby Digital and Dolby Digital Plus Dynamic Range Compression
- Adjust the Reference Level
- Adjust the Output Resolution
- Adjust 3D Mode
- Adjust the DVI Output Color Depth
- Adjust the Audio Monitor Channel
- Adjust the IP Address, Subnet, Gateway, Port, or Telnet Port
- Navigate the Main Menu System
- Adjust Video Settings
- Adjust the Audio Settings
- Adjust Advanced Audio Settings
- Manage Presets
- Manage Trigger Inputs
- Manage Trigger Outputs
- Use an External Microphone
- Monitor an Audio Channel
- Serial Control
- Web Interface
- Troubleshooting
- Specifications
- Supported Video Formats
- Supported Audio Formats
- Power
- Control and Network Ports
- Connections
- Physical
- Connector Pins
- Audio Pins
- Channel Mapping
- Default Settings
76 Christie Vive Audio SKA-3D User Manual
020-101056-02 Rev. 1 (10-2013)
Web Interface
LFE EQ Tab
C Bi-amp and Phase
Levels
Sets the high-frequency (HF) and low-frequency (LF) levels and low-frequency audio
phase. Levels range between 0 and -20 dB and the phase range is between 180° and
-180°. When Link is selected, the high and low frequencies are adjusted at the same
rate.
The Bi-amp L/C/R Configuration must be enabled to use this feature.
D Test Signal Generates a -20 dBFS pink noise test signal.
E High-Pass Filter Sets the high-pass filter frequency in 1 Hz increments between 5 and 150 Hz. Click
Enable to use this feature.
F Save and Load
Settings
Saves the current settings to a file, imports external settings to apply, or copies
settings from one channel to another. Click Copy To, to copy the current EQ settings
to the channel specified in the list. Available options include: Left, Right, Center,
Left Surround, Right Surround, Left Center, and Right Center. The channels
available for adjustment are dependent on the selected speaker configuration.
Ref. Item Description
ALFE Parametric
EQ
Sets the low frequency effects. Click Reset to reset the currently selected audio
channel to the default LFE EQ settings.
• Bandwidth (Band 1 - Band 4)
- move the slider to adjust the bandwidth in 5 Hz
increments between 5 and 60 Hz.
• HPF (High-Pass Filter) - select to enable the high-pass filter. Move the slider to
adjust the high-pass filter frequency in 1 Hz increments between 5 and 40 Hz.
• Amplitude (Band 1 - Band 4) - move the slider to adjust the amplitude from
-12 to 12 dB in 0.5 dB increments.
Ref. Item Description