User manual
Table Of Contents
- Important Safety Information
- Introduction
- Installation
- Operation
- Turn the Power On
- Turn the Power Off
- Manage Firmware
- Select a Video Input
- Select an Audio Input
- Adjust the Outputs
- Adjust the Audio Processing Mode
- Adjust the Auto Preset Select
- Adjust Dolby True HD Dynamic Range Compression
- Adjust Dolby Digital and Dolby Digital Plus Dynamic Range Compression
- Adjust the Reference Level
- Adjust the Output Resolution
- Adjust 3D Mode
- Adjust the DVI Output Color Depth
- Adjust the Audio Monitor Channel
- Adjust the IP Address, Subnet, Gateway, Port, or Telnet Port
- Navigate the Main Menu System
- Adjust Video Settings
- Adjust the Audio Settings
- Adjust Advanced Audio Settings
- Manage Presets
- Manage Trigger Inputs
- Manage Trigger Outputs
- Use an External Microphone
- Monitor an Audio Channel
- Serial Control
- Web Interface
- Troubleshooting
- Specifications
- Supported Video Formats
- Supported Audio Formats
- Power
- Control and Network Ports
- Connections
- Physical
- Connector Pins
- Audio Pins
- Channel Mapping
- Default Settings
Web Interface
Christie Vive Audio SKA-3D User Manual 73
020-101056-02 Rev. 1 (10-2013)
Audio Settings Screen
This section describes the Audio Settings screen tabs.
Speaker Configuration Tab
I Output Resolution Sets the output resolution. The video source frame rate is unaffected. No frame
rate conversion takes place.
J Size & Position Sets the image horizontal stretch (width), vertical stretch (height), and position.
Click Reset to reset the size and position values to 0.
K 3D Mode Sets the 3D output mode. Available options include:
• Sequential - the left and right eye 3D signals are over a single output. Use the
HDMI L output when using this mode.
• Dual-Output (default)- a separate left and right eye 3D signal is provided.
HDMI L is output for the left eye and HDMI R is output for the right eye.
L HDMI Output Color
Depth
Sets the HDMI color depth.
Ref. Item Description
ASpeaker
Configuration
Image
Provides a graphic representation of the current speaker configuration. Speakers
used in the speaker configuration are green, speakers not used are gray.
BSpeaker
Configuration
Sets the speaker configuration. Available options include: Mono C, Stereo L R, 3-
Screen + 2-Surrounds, 3-Screen + 4-Surrounds, 5-Screen + 2-Surrounds,
5-Screen + 4-Surrounds.
C Bi-amp Crossover
Type
Sets the bi-amp crossover type. Only the Linkwitz-Riley crossover is available at this
time.
D Bi-amp L/C/R
Configuration
Sets the crossover frequency for the left, center, and right speaker configuration.
Move the slider to adjust the frequency in 5 Hz increments between 40 and 4000 Hz
(4 kHz). Select the Enable check box to activate the crossover.
E Bi-amp LS and RS
to Aux 1/2
Sets the crossover frequency for the left and right side speakers to Aux 1/2. Move the
slider to adjust the frequency in 5 Hz increments between 40 and 4000 Hz (4 kHz).
Select the Enable check box to activate the crossover.
Ref. Item Description