User manual
Table Of Contents
- Important Safety Information
- Introduction
- Installation
- Operation
- Turn the Power On
- Turn the Power Off
- Manage Firmware
- Select a Video Input
- Select an Audio Input
- Adjust the Outputs
- Adjust the Audio Processing Mode
- Adjust the Auto Preset Select
- Adjust Dolby True HD Dynamic Range Compression
- Adjust Dolby Digital and Dolby Digital Plus Dynamic Range Compression
- Adjust the Reference Level
- Adjust the Output Resolution
- Adjust 3D Mode
- Adjust the DVI Output Color Depth
- Adjust the Audio Monitor Channel
- Adjust the IP Address, Subnet, Gateway, Port, or Telnet Port
- Navigate the Main Menu System
- Adjust Video Settings
- Adjust the Audio Settings
- Adjust Advanced Audio Settings
- Manage Presets
- Manage Trigger Inputs
- Manage Trigger Outputs
- Use an External Microphone
- Monitor an Audio Channel
- Serial Control
- Web Interface
- Troubleshooting
- Specifications
- Supported Video Formats
- Supported Audio Formats
- Power
- Control and Network Ports
- Connections
- Physical
- Connector Pins
- Audio Pins
- Channel Mapping
- Default Settings

64 Christie Vive Audio SKA-3D User Manual
020-101056-02 Rev. 1 (10-2013)
Serial Control
telnetport
Sets the telnet
listening port.
s telnetport [p1]
p1 options:
•
0...65535 - the
Telnet listening port.
The default value is
23.
s telnetport 26 Close telnet
user...
TELNET PORT 26
Returns the telnet
listening port.
r telnetport
none
r telnetport TELNET PORT 26
testnoise
Sets the pink noise
test signal for the
specified speaker
to enabled or
disabled.
s testnoise [p1]
[p2]
p1 options:
•
0 - Center
•
1 - Front Left
•
2 - Front Right
•
3 - Surround Left
•
4 - Surround Right
•
5 - Surround Back
Left
•
6 - Surround Back
Right
•
7 - Center Left
•
8 - Center Right
•
9 - Low Frequency
Effects (LFE)
p2 options:
•
0 - Off
•
1 - On
s testnoise 1 1 TESTNOISE FL :ON
Returns the pink
noise test signal
setting.
r testnoise [p1] r testnoise 1 TESTNOISE FL :ON
Command Description Syntax Parameters [p] Example Returned Value