User manual
Table Of Contents
- Important Safety Information
- Introduction
- Installation
- Operation
- Turn the Power On
- Turn the Power Off
- Manage Firmware
- Select a Video Input
- Select an Audio Input
- Adjust the Outputs
- Adjust the Audio Processing Mode
- Adjust the Auto Preset Select
- Adjust Dolby True HD Dynamic Range Compression
- Adjust Dolby Digital and Dolby Digital Plus Dynamic Range Compression
- Adjust the Reference Level
- Adjust the Output Resolution
- Adjust 3D Mode
- Adjust the DVI Output Color Depth
- Adjust the Audio Monitor Channel
- Adjust the IP Address, Subnet, Gateway, Port, or Telnet Port
- Navigate the Main Menu System
- Adjust Video Settings
- Adjust the Audio Settings
- Adjust Advanced Audio Settings
- Manage Presets
- Manage Trigger Inputs
- Manage Trigger Outputs
- Use an External Microphone
- Monitor an Audio Channel
- Serial Control
- Web Interface
- Troubleshooting
- Specifications
- Supported Video Formats
- Supported Audio Formats
- Power
- Control and Network Ports
- Connections
- Physical
- Connector Pins
- Audio Pins
- Channel Mapping
- Default Settings
30 Christie Vive Audio SKA-3D User Manual
020-101056-02 Rev. 1 (10-2013)
Operation
Manage Trigger Inputs
Trigger inputs provide communication with automation devices. The SKA-3D has 8 available trigger
inputs.
Configure Trigger Inputs
Configure trigger inputs using the web interface or the SKA-3D controls. It is useful to use the web
interface when multiple trigger inputs are set at one time. Use the SKA-3D controls to change
individual configuration settings.
Configure Trigger Inputs using the Web Interface
1. Open the SKA-3D web interface.
See Access the SKA-3D Web Interface on page 71.
2. Click the Automation tab.
3. Click the Trigger Inputs tab.
4. Select the Trigger Input from the list.
5. Select the Switch to Preset from the list.
6. Click Test to test the trigger input.
7. Repeat steps 4 to 6 for the remaining trigger inputs.
8. Click Save, and save the trigger inputs as an XML file.
Configure Trigger Inputs using the SKA-3D Controls
1. Press Menu.
2. Press the left or right navigation button to display Automation Settings.
3. Press Enter.
4. Press the up or down navigation button to display Trigger Inputs.
5. Press the left or right navigation button to select the automation trigger input to configure:
<1>...<8>
6. Press Enter and navigate to TRIGGER TYPE.
7. Press the left or right navigation button to configure the automation trigger input:
• <NORM HIGH>
• <NORM LOW>
8. Press the up or down navigation button to display SWITCH TO PRESET.
9. Press the left or right navigation button to select the preset to use when the trigger event is
called:
• <NONE>