User manual
Table Of Contents
- Important Safety Information
- Introduction
- Installation
- Operation
- Turn the Power On
- Turn the Power Off
- Manage Firmware
- Select a Video Input
- Select an Audio Input
- Adjust the Outputs
- Adjust the Audio Processing Mode
- Adjust the Auto Preset Select
- Adjust Dolby True HD Dynamic Range Compression
- Adjust Dolby Digital and Dolby Digital Plus Dynamic Range Compression
- Adjust the Reference Level
- Adjust the Output Resolution
- Adjust 3D Mode
- Adjust the DVI Output Color Depth
- Adjust the Audio Monitor Channel
- Adjust the IP Address, Subnet, Gateway, Port, or Telnet Port
- Navigate the Main Menu System
- Adjust Video Settings
- Adjust the Audio Settings
- Adjust Advanced Audio Settings
- Manage Presets
- Manage Trigger Inputs
- Manage Trigger Outputs
- Use an External Microphone
- Monitor an Audio Channel
- Serial Control
- Web Interface
- Troubleshooting
- Specifications
- Supported Video Formats
- Supported Audio Formats
- Power
- Control and Network Ports
- Connections
- Physical
- Connector Pins
- Audio Pins
- Channel Mapping
- Default Settings
Operation
Christie Vive Audio SKA-3D User Manual 25
020-101056-02 Rev. 1 (10-2013)
Adjust the BI-AMP LCR
1. Press Menu.
2. Press the left or right navigation button to display Adv. Audio Settings.
3. Press Enter.
4. Press the up or down navigation button to display BI-AMP LCR.
5. Press the left or right navigation button and select the bi-amp LCR setting:
• <DISABLE>
• <ENABLE>
6. Press Enter.
7. Press Exit until you return to the status screen.
Adjust the BI-Amp LCR Crossover Frequency
1. Press Menu.
2. Press the left or right navigation button to display Adv. Audio Settings.
3. Press Enter.
4. Press the up or down navigation button to display BI-AMP LCR XOVER.
5. Press the left or right navigation button to adjust the bi-amp LCR crossover frequency:
<00400Hz>...<4000Hz>
The crossover frequency is adjustable from 40-4000 Hz in 5 Hz increments.
6. Press Enter.
7. Press Exit until you return to the status screen.
Adjust the BI-Amp LC & RC to Aux 1/2
1. Press Menu.
2. Press the left or right navigation button to display Adv. Audio Settings.
3. Press Enter.
4. Press the up or down navigation button to display BI-AMP LC&RC to Aux.
5. Press the left or right navigation button to select the bi-amp LC and RC to aux 1/2 setting:
• <DISABLE>
• <ENABLE>
6. Press Enter.
7. Press Exit until you return to the status screen.