User manual
Table Of Contents
- Important Safety Information
- Introduction
- Installation
- Operation
- Turn the Power On
- Turn the Power Off
- Manage Firmware
- Select a Video Input
- Select an Audio Input
- Adjust the Outputs
- Adjust the Audio Processing Mode
- Adjust the Auto Preset Select
- Adjust Dolby True HD Dynamic Range Compression
- Adjust Dolby Digital and Dolby Digital Plus Dynamic Range Compression
- Adjust the Reference Level
- Adjust the Output Resolution
- Adjust 3D Mode
- Adjust the DVI Output Color Depth
- Adjust the Audio Monitor Channel
- Adjust the IP Address, Subnet, Gateway, Port, or Telnet Port
- Navigate the Main Menu System
- Adjust Video Settings
- Adjust the Audio Settings
- Adjust Advanced Audio Settings
- Manage Presets
- Manage Trigger Inputs
- Manage Trigger Outputs
- Use an External Microphone
- Monitor an Audio Channel
- Serial Control
- Web Interface
- Troubleshooting
- Specifications
- Supported Video Formats
- Supported Audio Formats
- Power
- Control and Network Ports
- Connections
- Physical
- Connector Pins
- Audio Pins
- Channel Mapping
- Default Settings
Operation
Christie Vive Audio SKA-3D User Manual 23
020-101056-02 Rev. 1 (10-2013)
• BLS < 00.0>FT
• BRS < 00.0>FT
• LC < 00.0>FT
• RC < 00.0>FT
• LFE < 00.0>FT
7. Press the left or right navigation button to configure the speaker distance.
The distance for each speaker can be adjusted from 0-169 ft. (0-51.5 m) in 0.5 (ft. / m)
increments.
8. Press Exit until you return to the status screen.
Adjust the Lipsync Delay
1. Press Menu.
2. Press the left or right navigation button to display Audio Settings.
3. Press Enter.
4. Press the up or down navigation button to display Lipsync Delay.
5. Press Enter.
6. Press the up or down navigation button and select the audio lipsync delay to configure:
• HDMI 1 < 000ms >
• HDMI 2 < 000ms >
• DVI-I < 000ms >
• DVI-D < 000ms >
• Comp1 < 000ms >
• Comp2 < 000ms >
• VGA < 000ms >
7. Press the left or right navigation button to configure the delay in milliseconds.
8. Press Exit until you return to the status screen.
Adjust the Phantom Power
1. Press Menu.
2. Press the left or right navigation button to display Audio Settings.
3. Press Enter.
4. Press the up or down navigation button to display Phantom Power.
5. Press Enter.