User manual
Table Of Contents
- Important Safety Information
- Introduction
- Installation
- Operation
- Turn the Power On
- Turn the Power Off
- Manage Firmware
- Select a Video Input
- Select an Audio Input
- Adjust the Outputs
- Adjust the Audio Processing Mode
- Adjust the Auto Preset Select
- Adjust Dolby True HD Dynamic Range Compression
- Adjust Dolby Digital and Dolby Digital Plus Dynamic Range Compression
- Adjust the Reference Level
- Adjust the Output Resolution
- Adjust 3D Mode
- Adjust the DVI Output Color Depth
- Adjust the Audio Monitor Channel
- Adjust the IP Address, Subnet, Gateway, Port, or Telnet Port
- Navigate the Main Menu System
- Adjust Video Settings
- Adjust the Audio Settings
- Adjust Advanced Audio Settings
- Manage Presets
- Manage Trigger Inputs
- Manage Trigger Outputs
- Use an External Microphone
- Monitor an Audio Channel
- Serial Control
- Web Interface
- Troubleshooting
- Specifications
- Supported Video Formats
- Supported Audio Formats
- Power
- Control and Network Ports
- Connections
- Physical
- Connector Pins
- Audio Pins
- Channel Mapping
- Default Settings
22 Christie Vive Audio SKA-3D User Manual
020-101056-02 Rev. 1 (10-2013)
Operation
5. Press Enter.
6. Press the up or down navigation button and select the audio channel to configure:
• C <0.0dB>
• L <0.0dB>
• R <0.0dB>
• LS <0.0dB>
• RS <0.0dB>
• BLS <0.0dB>
• BRS <0.0dB>
• LC <0.0dB>
• RC <0.0dB>
• LFE <0.0dB>
7. Press the left or right navigation button to configure the audio channel level.
Each channel level can be adjusted from -20.0 dB to 0.0 dB in 0.5
increments.
8. Press Exit until you return to the status screen.
Adjust the Speaker Distance
Use this procedure to set the individual speaker distances in meters or feet from the listening
position. The SKA-3D identifies the longest distance between all speakers and then references all
other speakers to this number. A delay is calculated for all speakers, except for the speaker with the
greatest distance.
1. Press Menu.
2. Press the left or right navigation button to display Audio Settings.
3. Press Enter.
4. Press the up or down navigation button to display Speaker Distance <Feet or Meters>.
If required, press the left or right navigation button to alternate between SPEAKER DISTANCE
<FEET> or SPEAKER DISTANCE <METERS>.
5. Press Enter.
6. Press the up or down navigation button and select the audio speaker to configure:
• C < 00.0>FT
• L < 00.0>FT
• R < 00.0>FT
• LS < 00.0>FT
• RS < 00.0>FT