User manual
Table Of Contents
- Important Safety Information
- Introduction
- Installation
- Operation
- Turn the Power On
- Turn the Power Off
- Manage Firmware
- Select a Video Input
- Select an Audio Input
- Adjust the Outputs
- Adjust the Audio Processing Mode
- Adjust the Auto Preset Select
- Adjust Dolby True HD Dynamic Range Compression
- Adjust Dolby Digital and Dolby Digital Plus Dynamic Range Compression
- Adjust the Reference Level
- Adjust the Output Resolution
- Adjust 3D Mode
- Adjust the DVI Output Color Depth
- Adjust the Audio Monitor Channel
- Adjust the IP Address, Subnet, Gateway, Port, or Telnet Port
- Navigate the Main Menu System
- Adjust Video Settings
- Adjust the Audio Settings
- Adjust Advanced Audio Settings
- Manage Presets
- Manage Trigger Inputs
- Manage Trigger Outputs
- Use an External Microphone
- Monitor an Audio Channel
- Serial Control
- Web Interface
- Troubleshooting
- Specifications
- Supported Video Formats
- Supported Audio Formats
- Power
- Control and Network Ports
- Connections
- Physical
- Connector Pins
- Audio Pins
- Channel Mapping
- Default Settings
Operation
Christie Vive Audio SKA-3D User Manual 17
020-101056-02 Rev. 1 (10-2013)
Adjust the DVI Output Color Depth
1. Press the up or down navigation button to display Video Output.
2. Press Enter.
3. Press the up or down navigation button to display DVI OUT COLOR.
4. Press the left or right navigation button to select the DVI output color depth:
• <8-BIT> - standard setting for HDMI and RGB color ranges from 0-255 (4:4:4 color
sampling). This setting is recommended for Series-1 projectors that only support HDMI on
the video inputs.
• <10-BIT> - used for HDMI with RGB color ranges from 0-1023 (4:4:4 color sampling).
This setting is recommended for Series-2 projectors that have the HDMI 1.3 receiver chip
and can support high-color depth signals.
5. Press Enter.
6. Press Exit until you return to the status screen.
Adjust the Audio Monitor Channel
1. Connect a set of stereo headphones to the Headphone Out jack or the Booth Monitor
(Fixed) connectors on the back.
2. Turn the Headphone Level knob, to control the headphone volume.
3. Press the Source Select button until the required channel for monitoring is displayed.
OR
1. Connect a set of stereo headphones to the Headphone Out jack or the Booth Monitor
(Fixed) connectors on the back.
2. Press the up or down navigation button to display Audio Monitor Ch.
3. Press the left or right navigation button to select the audio monitor channel:
• MIX
• LEFT
• RIGHT
• CENTER
• LFE
• LEFT SURROUND
• RIGHT SURROUND
• BACK LEFT SURROUND
• BACK RIGHT SURROUND
• LEFT CENTER