User manual
Table Of Contents
- Important Safety Information
- Introduction
- Installation
- Operation
- Turn the Power On
- Turn the Power Off
- Manage Firmware
- Select a Video Input
- Select an Audio Input
- Adjust the Outputs
- Adjust the Audio Processing Mode
- Adjust the Auto Preset Select
- Adjust Dolby True HD Dynamic Range Compression
- Adjust Dolby Digital and Dolby Digital Plus Dynamic Range Compression
- Adjust the Reference Level
- Adjust the Output Resolution
- Adjust 3D Mode
- Adjust the DVI Output Color Depth
- Adjust the Audio Monitor Channel
- Adjust the IP Address, Subnet, Gateway, Port, or Telnet Port
- Navigate the Main Menu System
- Adjust Video Settings
- Adjust the Audio Settings
- Adjust Advanced Audio Settings
- Manage Presets
- Manage Trigger Inputs
- Manage Trigger Outputs
- Use an External Microphone
- Monitor an Audio Channel
- Serial Control
- Web Interface
- Troubleshooting
- Specifications
- Supported Video Formats
- Supported Audio Formats
- Power
- Control and Network Ports
- Connections
- Physical
- Connector Pins
- Audio Pins
- Channel Mapping
- Default Settings
16 Christie Vive Audio SKA-3D User Manual
020-101056-02 Rev. 1 (10-2013)
Operation
Adjust the Output Resolution
1. Press the up or down navigation button to display Video Output.
2. Press Enter.
3. Press the up or down navigation button to display OUTPUT RES.
4. Press the left or right navigation button to select an output resolution:
• <1080P>
• <2K>
• <BY PASS>
1
5. Press Enter.
6. Press Exit until you return to the status screen.
Adjust 3D Mode
The SKA-3D supports the following 3D formats: side-by-side (half) at 1080i60 resolution, frame
packing (top/bottom) at 720p60 resolution, and frame packing (top/bottom) at 1080p24 resolution.
1. Press the up or down navigation button to display Video Output.
2. Press Enter.
3. Press the up or down navigation button to display 3D MODE.
4. Press the left or right navigation button to select the 3D mode:
• <SEQENTIAL> - sequential left and right eye 3D signal over a single output (Series 1
projectors). Use the HDMI L output when using this mode.
• <DUAL-OUT> - separate left and right eye 3D signal using HDMI L output for the left eye
and HDMI R output for the right eye (Series 2 projectors).
5. Press Enter.
6. Press Exit until you return to the status screen.
i
The SKA-3D does not have frame rate conversion. The video output frame rate follows the
input video frame rate.
1.Bypass mode bypasses all video scaling. Use Bypass mode if the projector will perform all video processing. Video
output resolution will be the same as the input resolution.