User manual
Table Of Contents
- Important Safety Information
- Introduction
- Installation
- Operation
- Turn the Power On
- Turn the Power Off
- Manage Firmware
- Select a Video Input
- Select an Audio Input
- Adjust the Outputs
- Adjust the Audio Processing Mode
- Adjust the Auto Preset Select
- Adjust Dolby True HD Dynamic Range Compression
- Adjust Dolby Digital and Dolby Digital Plus Dynamic Range Compression
- Adjust the Reference Level
- Adjust the Output Resolution
- Adjust 3D Mode
- Adjust the DVI Output Color Depth
- Adjust the Audio Monitor Channel
- Adjust the IP Address, Subnet, Gateway, Port, or Telnet Port
- Navigate the Main Menu System
- Adjust Video Settings
- Adjust the Audio Settings
- Adjust Advanced Audio Settings
- Manage Presets
- Manage Trigger Inputs
- Manage Trigger Outputs
- Use an External Microphone
- Monitor an Audio Channel
- Serial Control
- Web Interface
- Troubleshooting
- Specifications
- Supported Video Formats
- Supported Audio Formats
- Power
- Control and Network Ports
- Connections
- Physical
- Connector Pins
- Audio Pins
- Channel Mapping
- Default Settings
Christie Vive Audio SKA-3D User Manual 11
020-101056-02 Rev. 1 (10-2013)
Operation
This section provides procedures and information for operating the SKA-3D.
Turn the Power On
1. Make sure the power cord is connected.
2. Move the AC power switch to the on position.
Turn the Power Off
Move the AC power switch to the off position.
Manage Firmware
The SKA-3D ships with the latest firmware. This section describes how to view the current firmware
version and how to update the firmware.
Display the Firmware Version
1. Press the up or down navigation button to display Christie Digital SKA-3D.
2. Press the right navigation button to display the current firmware and boot code.
3. Press Exit to return the status screen.
Update the Firmware
1. Turn the SKA-3D power on.
See Turn the Power On on page 11.
An incorrect power setup creates a fire and shock hazard. Do not operate the SKA-3D unless
the power cord, power socket, and power plug meet the appropriate local rating standards.
Have a certified electrician install a permanent single-phase connection from the amplifier to
the AC supply for correct installation. Failure to comply could result in death or serious
injury.
Never try to hold the AC power switch in the on position if it does not stay there itself.
Failure to comply may result in equipment or property damage.
i
Save the current system settings before updating the firmware. From the web interface,
open the System Configuration screen and click Backup in the System Settings pane.