User manual
Table Of Contents
- Important Safety Information
- Introduction
- Installation
- Operation
- Turn the Power On
- Turn the Power Off
- Manage Firmware
- Select a Video Input
- Select an Audio Input
- Adjust the Outputs
- Adjust the Audio Processing Mode
- Adjust the Auto Preset Select
- Adjust Dolby True HD Dynamic Range Compression
- Adjust Dolby Digital and Dolby Digital Plus Dynamic Range Compression
- Adjust the Reference Level
- Adjust the Output Resolution
- Adjust 3D Mode
- Adjust the DVI Output Color Depth
- Adjust the Audio Monitor Channel
- Adjust the IP Address, Subnet, Gateway, Port, or Telnet Port
- Navigate the Main Menu System
- Adjust Video Settings
- Adjust the Audio Settings
- Adjust Advanced Audio Settings
- Manage Presets
- Manage Trigger Inputs
- Manage Trigger Outputs
- Use an External Microphone
- Monitor an Audio Channel
- Serial Control
- Web Interface
- Troubleshooting
- Specifications
- Supported Video Formats
- Supported Audio Formats
- Power
- Control and Network Ports
- Connections
- Physical
- Connector Pins
- Audio Pins
- Channel Mapping
- Default Settings
Christie Vive Audio SKA-3D User Manual 9
020-101056-02 Rev. 1 (10-2013)
Installation
1. Slide the SKA-3D into your rack.
Provide 1U of space above and below the SKA-3D. Do not place the SKA-3D directly above or
below a heat source such as a power amplifier or server. If the SKA-3D is not rack-mounted,
never place another piece of equipment (or heat source) above or below the SKA-3D.
2. Install the SKA-3D rack ears.
3. While holding the SKA-3D in position, insert a screw through each of the rack mounting ears.
4. Tighten the screws to secure the SKA-3D to the rack.
5. Connect one end of the power cord to the AC power inlet and the other end to a power outlet.
6. Connect the output and input connectors.
See Connections on page 6 for connection locations.
An incorrect power setup creates a fire and shock hazard. Do not operate the SKA-3D unless
the power cord, power socket, and power plug meet the appropriate local rating standards.
Have a certified electrician install a permanent single-phase connection from the amplifier to
the AC supply for correct installation. Failure to comply could result in death or serious
injury.
Make sure the SKA-3D is properly ventilated. Provide 1U of space above and below the SKA-
3D. Make sure that vents are not blocked and that air can flow freely through the unit. Do
not place the SKA-3D directly above or below a heat source such as a power amplifier or
server. If the SKA-3D is not rack-mounted, never place another piece of equipment (or heat
source) on top or below the SKA-3D.