User manual
Table Of Contents
- Important Safety Information
- Introduction
- Installation
- Operation
- Turn the Power On
- Turn the Power Off
- Manage Firmware
- Select a Video Input
- Select an Audio Input
- Adjust the Outputs
- Adjust the Audio Processing Mode
- Adjust the Auto Preset Select
- Adjust Dolby True HD Dynamic Range Compression
- Adjust Dolby Digital and Dolby Digital Plus Dynamic Range Compression
- Adjust the Reference Level
- Adjust the Output Resolution
- Adjust 3D Mode
- Adjust the DVI Output Color Depth
- Adjust the Audio Monitor Channel
- Adjust the IP Address, Subnet, Gateway, Port, or Telnet Port
- Navigate the Main Menu System
- Adjust Video Settings
- Adjust the Audio Settings
- Adjust Advanced Audio Settings
- Manage Presets
- Manage Trigger Inputs
- Manage Trigger Outputs
- Use an External Microphone
- Monitor an Audio Channel
- Serial Control
- Web Interface
- Troubleshooting
- Specifications
- Supported Video Formats
- Supported Audio Formats
- Power
- Control and Network Ports
- Connections
- Physical
- Connector Pins
- Audio Pins
- Channel Mapping
- Default Settings
8 Christie Vive Audio SKA-3D User Manual
020-101056-02 Rev. 1 (10-2013)
Introduction
IPhoenix
connectors (Audio
Out)
Accepts single audio channel outputs: L Low, C Low, R Low, Aux 1 LS Low, Aux 2 RS
Low, HI, VI / N. These can be configured using the web interface or serial control
commands.
J Booth Monitor
(Fixed)
Accepts an L/R RCA-type cable for the projection booth monitors output. The audio
output level is fixed and is controlled by the external amplification device / monitors.
K AC power inlet Accepts an AC power cord.
L Contact Closure
Inputs (1-8)
Accepts Phoenix-type connectors for control of devices using contact closure.
MRelay Outputs
(1-4)
Accepts up to four controlled device inputs to these trigger outputs to control
screens, drapes, lights, or other devices. Connect trigger wires to removable terminal
block plugs.
N RS-232 Accepts an RS-232 serial connector to control other devices.
O Ethernet Accepts an Ethernet connection, to connect the A/V Cinema Scaler 3D to a network in
order to use IP control.
P HDMI 1 Accepts an HDMI cable from the source to this HDMI connector.
Q HDMI 3 / DVI-I Accepts a DVI (analog or digital) cable from the source to this DVI connector. This
input also accepts HDMI audio.
R Comp 1 Accepts three Component (YPbPr) video cables from the source to these
RCA-type connectors.
S HDMI L / DVI-D Outputs the left-eye video signal from a 3D source.
T HDMI R / DVI-D Outputs the right-eye video signal from a 3D source.
Ref. Item Description