User manual
Table Of Contents
- Important Safety Information
- Introduction
- Installation
- Operation
- Turn the Power On
- Turn the Power Off
- Manage Firmware
- Select a Video Input
- Select an Audio Input
- Adjust the Outputs
- Adjust the Audio Processing Mode
- Adjust the Auto Preset Select
- Adjust Dolby True HD Dynamic Range Compression
- Adjust Dolby Digital and Dolby Digital Plus Dynamic Range Compression
- Adjust the Reference Level
- Adjust the Output Resolution
- Adjust 3D Mode
- Adjust the DVI Output Color Depth
- Adjust the Audio Monitor Channel
- Adjust the IP Address, Subnet, Gateway, Port, or Telnet Port
- Navigate the Main Menu System
- Adjust Video Settings
- Adjust the Audio Settings
- Adjust Advanced Audio Settings
- Manage Presets
- Manage Trigger Inputs
- Manage Trigger Outputs
- Use an External Microphone
- Monitor an Audio Channel
- Serial Control
- Web Interface
- Troubleshooting
- Specifications
- Supported Video Formats
- Supported Audio Formats
- Power
- Control and Network Ports
- Connections
- Physical
- Connector Pins
- Audio Pins
- Channel Mapping
- Default Settings
Specifications
Christie Vive Audio SKA-3D User Manual 107
020-101056-02 Rev. 1 (10-2013)
Channel Mapping
Phantom Power
Automation Settings
This section provides the default automation settings.
Presets
Center Frequency Band 1: 130 Hz
Band 2: 130 Hz
Band 3: 130 Hz
Band 4: 130 Hz
Low frequency effects (LFE) Level (dB) 0.0
Phase (Deg) 0
Test Signal (Pink Noise, -20 dBFS) Off
Setting Default Value
Aux 1 Channel Source: None
Output Level: Fixed
Aux 2 Channel Source: None
Output Level: Fixed
HI Channel Source: None
Output Level: Fixed
VI/N Channel Source: None
Output Level: Fixed
Setting Default Value
Phantom power Off
Setting Default Value
Preset 1...Preset 10 Preset name: PresetName
Switch to Video Input: HDMI 1
Switch to Audio Input: Digital DCI AES
Switch to Audio Mode: DCI 8 Channel Mapping 7.1
Set Master Volume Level: No Change
Custom Vol. Level: 0.0
Setting Default Value