User manual

TVC-500 Operation Manual 1-1
020-100539-01 Rev. 1 (08-2010)
1 Introduction
1.1 Using this Manual
This manual provides technical information on using the TVC-500 Controller and assisting Christie accredited
service technicians in its service and repair.
To prevent physical injury or equipment damage, it is important that you read Section 4
Service Guidelines in its entirety before performing any service procedure covered in this manual.
Disclaimer: Every effort has been made to ensure the information in this document is accurate and reliable.
However, due to constant research, the information in this document is subject to change without
notice. Christie Digital Systems assumes no responsibility for omissions or inaccuracies.
Updates to this document are published regularly, as required. Please contact Christie Digital
Systems for availability.
NOTE: Images in this manual are presented to illustrate the key steps for each service procedure.
1.2 Safety Warnings and Guidelines
1.2.1 Power Cords and Attachments
1) The North American rated line cord is provided with each unit. Ensure that you are
using a line cord, socket and power plug that meets the appropriate local rating standards.
2) Use only
an AC power cord recommended by Christie. Do not attempt operation if the AC supply and cord are
not within the specified voltage and power range.
Use only the attachments and/or accessories recommended by Christie. Use of others may result in the
risk of fire, shock or personal injury.
1.2.2 Symbols and Labels for the TVC-500 Controller
Warning Labels
Observe and follow all warnings and instructions marked on the chassis, the components in the controller and
in this document. The following symbols indicate potential hazards.