User manual

Section 6: Chassis Component Replacement
TVC-500 Operation Manual 6-15
020-100539-01 Rev. 1 (08-2010)
6.12.2 Replacement
1. Angle the replacement card into the
card guide. Align the PCIe card
keyway with the slot key. Firmly
seat the card in the slot (1 in Figure
6-29).
2. Re-attach any connectors that were
previously connected to the
removed card.
3. Close the retention clamp by
rotating it downward (2 in Figure 6-
29).
NOTE: It is normal for the retention
clamp to have a slight (5-10 degree)
angle when closed. If the angle is
greater than this, open the clamp and
ensure all cards are properly seated and
all the brackets are mated to the
chassis. Close the clamp.
NOTE: The retention clamp is secured by the expansion card support.
4. Install the expansion card support (6.5.2) if no further service is to be performed.
Figure 6-28 Expansion Card Removal
Figure 6-29 Expansion Card Replacement