User manual

6-14 TVC-500 Operation Manual
020-100539-01 Rev. 1 (08-2010)
Section 6: Chassis Component Replacement
6.12 Expansion Cards
Removal and replacement of cards in the expansion slots is described here.
6.12.1 Removal
Figure 6-27 Expansion Card Slots
1. Ensure the TVC-500 controller is
powered down. Refer to Section 6.2
Powering Down the Controller.
2. Remove the side access panel (6.3.1)
if not already removed.
3. Remove the expansion card support
(6.5.1) if not already removed.
4. Disconnect all cables connected to
the card (example circled in Figure
6-27).
5. Raise the rear retention clamp by
lifting the metal bar or the green
lever (1 in Figure 6-28).
6. Release the PCIe card latch (2 in
Figure 6-28), then carefully lift the card from the chassis (3 in Figure 6-28).
NOTE: The PCI (white socket) slot is not used in the TVC-500.
Figure 6-25 Open DIMM Socket Levers Figure 6-26 Installing DIMM