User manual

Section 6: Chassis Component Replacement
TVC-500 Operation Manual 6-13
020-100539-01 Rev. 1 (08-2010)
6.11.1 Removal
1. Ensure the TVC-500 controller is powered down.
Refer to Section 6.2 Powering Down the
Controller.
2. Remove the side access panel (6.3.1) if not already
removed.
3. Remove the airflow guide (6.4.1) if not already
removed.
4. Remove the memory fans (6.10).
5. Carefully push outward on the memory slot socket
levers (1 in Figure 6-23). Lift the DIMM straight
up and out of its socket (2 in Figure 6-23).
6.11.2 Replacement
123
4
56
Figure 6-24 Memory Module Installation Order
CPU
DIMMs must be installed in the order
shown in Figure 6-24.
NOTICE! Ensure the TVC-500
controller is powered down.
NOTE: Slots 1, 2 & 3 have black sockets
and 4, 5 & 6 have white sockets.
NOTE: For best performance, add
DIMMs of the same size in pairs.
1. Push outward on the DIMM socket
levers (Figure 6-25).
2. Align the DIMM connector key with
the DIMM socket key and seat the
DIMM firmly in the socket as shown
in Figure 6-26.
3. Secure the socket levers (2 in Figure 6-26).
Figure 6-23Remove Memory Module