User manual

Section 6: Chassis Component Replacement
TVC-500 Operation Manual 6-11
020-100539-01 Rev. 1 (08-2010)
2. Lift out the bottom of the fan to be replaced and remove it (Figure 6-19).
Figure 6-19 Removal/Replacement of Fan from Fan Holder
6.9.2 Replacement
1. Orient the replacement fan so that the fan label points into the expansion card guide/front fan holder.
2. Insert the fan cable under the fan holder hooks (1 in Figure 6-19). Rotate the fan near the retention tab and
press it until it snaps into place (2 in Figure 6-19).
3. Guide the fan cable under the cable retention clamps (illustrated in 6.9.1).
4. Install the fan holder in the reverse order of removal (6.9.1).
6.10 Memory Fans
Removal and replacement of this assembly is described here.
6.10.1 Removal
1. Ensure the TVC-500 controller is powered down. Refer to Section 6.2 Powering Down the Controller.
2. Remove the side access panel (6.3.1) if not already removed.
3. Remove the airflow guide (6.4.1) if not already removed.
4. Grasp the sides of the memory fan assembly (1 in Figure 6-20) and press the release tabs (2 in Figure 6-20)
with index fingers.
5. Lift the assembly upward, out of the chassis, as shown in Figure 6-22