User manual

Section 6: Chassis Component Replacement
TVC-500 Operation Manual 6-9
020-100539-01 Rev. 1 (08-2010)
6.8.2 Replacement
NOTE: Bays 1 and 2 in Figure 6-15 are
occupied by SATA drives as configured by
Christie. When replacing drives, ensure
that the drive containing the operating
system always occupies the same bay.
1. Using the hard drive carrier from
6.8.1, set the replacement hard drive
in the carrier at an angle (Figure 6-
16). Carefully separate the lower
carrier rails (1 in Figure 6-16), then
lower the drive between them. Align
the carrier pins with the drive
mounting holes and release the rails
to secure the lower end of the drive in
place.
2. Carefully separate the upper carrier
rails (2 in Figure 6-16), then rotate
the drive upright (3 in Figure 6-16).
3. While keeping the hard drive carrier
handle in its fully open position, slide
the hard drive into the bay until it
comes to a hard stop. When the drive
is installed, rotate the handle until it
snaps into place, fully securing the
drive.
NOTE: The hard drive carrier handle is used as a lever to properly seat the connectors and to securely retain
the hard drive. If the handle is closed prematurely, the proper connection is not made and the hard drive is not
retained properly.
Figure 6-15 Hard Drive Bays
1
2
3
4
Figure 6-16 Replacing Hard Drive in Carrier