User manual

6-8 TVC-500 Operation Manual
020-100539-01 Rev. 1 (08-2010)
Section 6: Chassis Component Replacement
6.8 Hard Drive (SATA)
Removal and replacement of a hard drive is described here.
6.8.1 Removal
Figure 6-12 Hard Drive Carrier Release Latch
1. Ensure the TVC-500 controller is
powered down. Refer to Section 6.2
Powering Down the Controller.
2. Remove the side access panel (6.3.1)
if not already removed.
3. Press the hard drive carrier release
latch at the green touch point and
rotate the handle outward (Figure 6-
12).
4. Pull the drive carrier out of the hard drive bay (Figure 6-13).
5. Carefully separate the upper hard drive carrier rails (1 in
Figure 6-14), then tilt the drive outward (2 in Figure 6-14).
6. Carefully separate the lower carrier rails (3 in Figure 6-14), then remove the drive from the carrier.
Figure 6-13 Hard Drive Carrier
Removal
Figure 6-14 Removing Hard Drive from Carrier