User manual

6-6 TVC-500 Operation Manual
020-100539-01 Rev. 1 (08-2010)
Section 6: Chassis Component Replacement
6.6 Power Supply
Removal and replacement of the power supply is described here.
6.6.1 Removal
1. Ensure the TVC-500 controller is powered down. Refer to Section 6.2 Powering Down the Controller.
2. Remove the side access panel (6.3.1) if not already removed.
3. Pull out the power supply locking handle marked with the green label (1 in Figure 6-8 left).
4. Use the handle to pull the power supply out of the chassis (2 in Figure 6-8 left).
Figure 6-8 Power Supply Removal
6.6.2 Replacement
Figure 6-9 Power Supply Features
In Figure 6-8 right, the power supply
slot in the chassis can be seen. Note the
shape of the power supply in Figure 6-9.
It can only be oriented one way when
installing it in the chassis slot.
1. Slide the power supply into the
chassis, keeping the handle
completely open.
2. When the power supply handle
engages the chassis, rotate the
handle inward until it snaps into
place to secure the power supply.