User manual

5-8 TVC-500 Operation Manual
020-100539-01 Rev. 1 (08-2010)
Section 5: Troubleshooting
202 Memory Type
Mismatch
Memory modules do not
match.
Replace the memory modules with matched sets.
203 Memory module
failed self-test
and failing rank
was disabled
Defective memory mod-
ule.
Replace the memory module.
204 Memory module
failed and user
rank was disabled
Improper module load. Reseat the memory module correctly.
205 Memory high
temperature
detected
Insufficient memory
module cooling.
Verify that a memory module cooling fan is installed and
operating.
206 Memory setup
invalid
Memory configured
incorrectly.
Reconfigure the memory modules in the proper slots.
207 Incompatible
DIMMs detected
DIMMs are installed that
do not fulfill system
requirements.
1. Verify that the memory module type matches workstation
requirements.
2. Insert the DIMM in the proper memory socket.
3. Replace the DIMM if the problem persists.
208 Mismatched
DIMMs detected
Installed DIMMs are
improperly matched.
Verify that matching DIMMs are installed.
209 Memory warning
condition
detected
Incorrect memory module
type in use.
Verify that the memory modules are compatible with work-
station requirements.
212 Failed Processor
0
Processor has failed to
initialize.
1. Reseat the processor in its socket.
2. If the processor does not respond, replace it.
213 Incompatible
Memory Modules
A memory module in the
memory socket identified
in the error message is
missing critical SPD
information, or is incom-
patible with the chipset.
1. Verify the memory module type.
2. Insert the DIMM in another memory socket.
3. Replace the module with a DIMM conforming to the SPD
standard.
214 DIMM Configu-
ration Warning
DIMMs are not installed
correctly (not paired cor-
rectly).
See the service label on the workstation access panel for the
correct memory configurations, and reseat the DIMMs
accordingly.
215 DIMM Configu-
ration Error
216 Memory Size
Exceeds Maxi-
mum Supported
The amount of memory
installed exceeds that
supported by the hard-
ware.
1. Verify how much memory the workstation supports.
2. Remove the excess memory.
301 Keyboard Error Keyboard failure.
1. Reconnect the keyboard with the workstation powered OFF.
2. Check the connector for bent or missing pins.
3. Be sure that none of the keys are pressed.
4. Replace the keyboard.
Table 5.3 Post Error Messages
Screen Messages Probable Cause Recommended Action