User manual

Section 3: Connecting the Controller
TVC-500 Operation Manual 3-3
020-100539-01 Rev. 1 (08-2010)
3.2 Connecting Devices to the TVC-500
Input and display modules can be installed in the TVC-500.
3.2.1 About Source Connections
The controller comes pre-configured. You should be able to connect your sources and display content on the
display wall when the unit is unpacked. This section provides a high-level overview of the capabilities of the
modules available for this controller. It also touches on some system configuration information. All Input and
Display modules are clearly labeled.
V8C Module
The V8C module is installed into the controller to allow connection of composite sources. A single V8C
module has 16 built-in decoders, but only 8 are available at a time through the module’s bottom connector. The
top connector is designated for audio input, but is not used. Composite video can be connected to any of the
available BNC inputs. Refer to Figure 3-2.
A maximum of 2 V8C modules can be installed in the TVC-500.
D2R2-E Module
A maximumof 2 D2R2-E modules can be installed
into a TVC-500. This module provides both analog
component (RGB) and digital (DVI) inputs Figure 3-
3. For channel configuration refer to Figure 3-1 and
Table 3.1. Each D2R2-E has 2 connectors. An RGB or
DVI source connected to the top connector is
considered Input 1.
If one of the D2R2-E modules is replaced, ensure that
the jumper settings of the new module matches the
jumper settings of the replaced module.
Figure 3-2 V8C Connections
Figure 3-3 D2R2-E Module