User`s manual

PARTS & MODULE REPLACEMENT
8
CP2000-X Parts & Module Replacement
AC DISTRIBUTION MODULE (ACDM)
(15 minutes)
The AC Distribution Module is located
in the igniter area between the lamp
blower and the liquid cooling system.
To remove:
1) Remove igniter door.
2) Remove lamp blower vane switch
bracket (one 3/8” nut).
3) Remove the ACDM mounting plate
(3 screws), and lift the assembly
from its slotted-hole mount on the
interior wall. See right.
4) Disconnect 2 ACDM ground wires
from the projector floor (1 screw).
5) Disconnect all connectors from the
ACDM, and swap on to the new
ACDM.
When reconnecting
:
 Connect pairs of brown and blue
wires with brown on top, and
blue on bottom.
AC RELAY MODULE
Refer to the CP2000/XP2000 Parts & Module Replacement Booklet
.
AC VOLTMETER
Refer to the Roadie 25K Parts & Module Replacement Booklet
.
COLD MIRROR
Refer to the CP2000/XP2000 Parts & Module Replacement Booklet
.
DOUSER (SHUTTER)
Refer to the CP2000/XP2000 Parts & Module Replacement Booklet
.
ENHANCED FORMATTER INTERFACE BRD. (EFIB)
(15 minutes)
The three main processing boards are mounted vertically in the electronics card
cage, where each connects to a motherboard on the floor of the card cage. The
Enhanced Formatter Interface Board (EFIB) is closest to the light engine, with 3
pairs of flex cables attached. To replace:
1) Remove the projector front lid. See Removing the Covers.
2) Remove card cage lid (6 screws)—pull firmly.