Setup guide

Section 2: Installation and Setup
CP2000 Setup Guide 2-21
020-100070-01 Rev. 1 (10/08)
In rare cases where additional tilt is needed, you can utilize the rear extender legs as described
below.
IMPORTANT! For best optical performance, avoid tilting the projector excessively. Instead use
vertical offset of the lens.
1. Remove the rear bottom panel (two top screws, two bottom tabs) from the CP pedestal
(Figure 2-30).
FIGURE 2-30 OPEN REAR OF PROJECTOR
2. Use a low-profile scissor jack to elevate the rear of the projector.
FIGURE 2-29 ADJUST 4 FEET FOR TILT AND LEVELING