Setup guide

3-8 M Series Setup Guide
020-100011-06 Rev. 1 (05-2013)
Section 3: Operation
Within A Presentation: Press FUNC followed by two numeric numbers to
enable a specific color or colors in the display. For example,
will display only red, and will display green data.
Eliminating one or more colors can help with certain diagnostics and setups,
such as when accurately overlaying one image on top of another from
stacked projectors.
NOTE: Color enabling can also be implemented from numerous locations
within the menu system.
Press F
UNC followed by HELP to disable Keystone, Edge Blending and
Brightness Uniformity settings. This will disable the features without
changing the settings associated with them.
Projector
Press P
ROJ to access a specific projector within a group of projectors or to confirm if the local projector is
listening. The number in the “Enter Number” window indicates which projector is currently listening to
commands, and will match the projector number that has been defined in the Menu Preferences menu.
The P
ROJ check box (read-only) shows whether or not the projector physically connected to a keypad is
listening to commands from that keypad. A check mark means that connected projector is listening; if there is
no check mark, you are communicating with a different projector.
To control a specific projector with the keypad, press P
ROJ and then enter the three-digit number assigned to
the projector you want to use. If you switch to a projector other than the one you are currently using, the check
mark will disappear.
To broadcast to multiple projectors, press P
ROJ and then PROJ again without entering a projector number.
Keypad commands will then effect all projectors present.
NOTES: 1) There is no method of controlling a group of projectors within the same wired configuration using
the wired keypad exclusively, since there is only one wired protocol available. 2) The projector’s address can
be set in the Configuration Menu > Communications Submenu.
Enter
Press E
NTER to select a highlighted item, to toggle a check box, or to accept a parameter adjustment and return
to the previous menu or image.
Exit
Press E
XIT to return to the previous level, such as the previous menu.
NOTE: E
XIT does not save changes within text editing boxes (including number editing of a slide bar value) or
within pull-down lists. In these cases, E
XIT acts as a “cancel”.
Arrow Keys
Use the LEFT/RIGHT ARROW KEY to change a slide bar value or to select a different option within a pull-down
list without having to first scroll through options or navigate within a menu, pull-down list or text box.
Lens H and Lens V
When adjusting the image for focus, zoom or horizontal and vertical positioning, use the specific arrow keys
(L
EFT/RIGHT ARROW KEY or UP/DOWN ARROW KEY) related to each function. A small window will appear to
indicate the type of adjustment taking place. For example,