Setup guide

2-10 M Series Setup Guide
020-100011-06 Rev. 1 (05-2013)
Section 2: Installation and Setup
2.2.6 Projector Communications
Status LEDs
Looking from the back of the projector, the LEDs represent, from left to right; Lamp 1, Lamp 2, Power, and
Status. The LEDs will display the colors as shown below:
PROJECTOR STATE LEDS LED STATE
Hard Boot All
All LEDs amber - means please wait
Standby Mode Lamp 1 and 2
Off - lamps are off
Power
Amber - AC is present but projector is off or
standby
Shutter
Green - shutter is open
Amber - shutter is closed
Warm-up (Powering ON from standby) All LEDs cycle green from left to right
Normal Operation Lamp 1 and 2
Amber - lamp time has expired and lamp should
be replaced
Power
Green - projector is powered up and operating
normally
Shutter
Green - shutter is open
Amber - shutter is closed
Cool-down All LEDs cycle amber from left to right
Error
Lamp 1 and 2
Amber - lamp time has expired and lamp should
be replaced
Flashing Red - lamp has malfunctioned
Power
Flashing Red - error has occurred. Details are
displayed on the status display
Software Upgrade in progress All The pattern will alternate between:
Amber and Off
Lamp Regeneration in progress Lamp 1 and 2
Flashing Green - the lamp is being switched
off for its regeneration period to extend lamp life
(typically 15 minutes every 24 hours)
Power
Green - on
-OR-
Amber - standby
Shutter
Green - shutter is open
NOTE: A condition occurs on the first power on after a software upgrade, and is indicated by all the following:
• The Status LEDs are cycling green
• The LCD displays the warning “Image Processor Upgrading”
• The LED on the Image Processor card flashes green
• The Web page shows a warning that the Image processor card is upgrading.
When this occurs, the projector should not be AC power cycled and the Image Processor card should not be removed.