User`s manual

72
38-FP0001-01
2. To search other input signal connected to the monitor, press
[Source] key of remote control again while the input signal type
is displayed.
･･
The searching order of other input signal is as follows.
[Analog RGB1] → [Analog RGB2] → [Digital RGB] → [Composite Video] →
[S-Video] → [Component Video] → [RGB+C Sync]
･･
Every time the input signal is searched, display the searched and stop
searching picture.
･･
"No input signal. Going to Sleep." is displayed when there is no other
input signal detected.
Numeric keys
6
As shown in page 45,46, each numeric keys is designated to one input signal
(see list below). Once any numeric key is pressed, signal detection starts. If no
correspondent signal is detected, next detection starts for other signal type.
Key
Source
1
2
3
4
5
6
7
Analog RGB1
Digital RGB
Composite Video
S-Video
Analog RGB2
Component Video
RGB+C Sync
Zoom menu
7
1. To show zoom menu, press [Zoom] key.
The zoom menu icon is displayed as follows.
2. To zoom in, press [ ] key.
−＋
3. To zoom out, press [ ] key.
Press [Escape] key to leave the Zoom menu.