Use and Care Manual

5
5. Operation
- Connect the power cord to the driver as shown below, twist the knob on the power cord to secure it onto
the driver. Do not force the connection as this can cause damage to the driver and power cord.
- To avoid accident and injury, check driver’s torque setting, and make sure that the work piece is fixed
firmly before operating.
- Change torque settings: Use the regulating handle to set the torque. Turning it clockwise into the casing will
increase the torque. Turning it counterclockwise out of the casing will decrease the torque.
Note: The engraved markings on the engraving ring are for reference only and does not indicate
actual torque output. Torque output can only be determined by repeated testing with a torque meter.
To prevent your torque setting from being tempered, an optional torque cover is available, which
covers and secures the regulating handle.
- Bit insertion: press the slide sleeve into the screwdriver and insert an appropriate bit. When the slide sleeve
is released, the bit will be automatically locked.
.
Illustration of insertion of bits
Illustration of torque setting
Figure 1 Figure 2 Figure 3