Instruction Manual

Android Device Operation
To use Mojo with an Android device you will need an ‘on the go’ cable ( OTG ). This is a special cable
that tells the Android device to run in host mode and enable USB audio. Some devices with newer
Android operating system ( 5 and above ) will then play all audio into Mojo. If this does not work then
you need to download either USB Audio Player Pro or Onkyo HF player to enable USB audio support.
Both are available from the Google Play store.
Apple iPad/iPhone Operation
In order to use USB audio you will require an Apple device running iOS6 or later and it needs the
lightning connector rather than the old 30 pin connector.
You require the Apple camera connection kit which will enable a standard USB connection from the
lightning port. Use this cable with the short USB to micro USB cable to connect Mojo. All audio will
then play through Mojo.
Onkyo HF player can be used to support high resolution audio including DSD.
De-emphasis coding
Mojo will automatically detect when a pre-emphasized recording is being played, and will set the
correct de-emphasis filters in the converter section.
DSD decoding
DSD playback is supported using the DoP Standard 1.0 with 0xFA / 0x05 markers. Please see the
playback software manual for more details on configuring DSD support.
- ! -7