Instruction Manual

Sample Rate Indication
The power ball will illuminate when a digital signal is connected and show the sample rate detected.
The table below shows the colours and the corresponding sample rate.
Brightness Setting
Mojo has two brightness settings for the illumination. Once Mojo has switched on and finished the
initialisation briefly press both volume buttons at the same time to change between bright and dim
modes.
Line Level Mode
To set the output level to 3V ( line level ) for connection to a preamplifier press both volume buttons
together when switching on the unit. Both volume balls will illuminate light blue. This mode is not
remembered so when you switch off it will reset back to the previous volume stored for safety reasons.
Memory
Mojo has a memory function that will store the volume level and brightness settings even after the unit
is switched off.
Audio Outputs
There are two 3.5mm stereo jack socket outputs for headphones. Both can be used at the same time and
will drive all headphones and in ear monitors (with the exception of electrostatic) from 8 ohms
impedance to 600 ohms. The outputs are also short circuit protected.
Digital Inputs
Mojo has 3 digital inputs.
1 x TOSLink optical capable of playing 44.1KHz to 192KHz PCM and DSD64 in DoP format.
1 x 3.5mm COAX SPDIF capable of playing 44.1KHz to 384Khz PCM (768KHz special operation)
and DSD64, DSD128 in DoP format.
1 x micro USB capable of 44KHz to 768KHz PCM and DSD64, DSD128 and DSD256 in DoP format.
Driverless on Mac, Android and Linux OS. However Windows Vista, 7, 8, and 10 will require a driver
which can be found on our Mojo webpage.
- ! -4