User Manual

Chord Electronics

2go | User manual

External network

2go can connect to an available Wi-Fi network. This option is enabled when Airplane Mode and Hotspot

Mode are deselected in the Settings tab

1. In the Settings tab

, press Wi-Fi to select or manually add a network.

2. Select an available network from the list. Enter the password and press Submit to connect.

3. Press Manually add network and enter the name and password of the network you want to add.

Press Done to connect.

TIP

2go can also connect to a Wi-Fi hotspot generated by a mobile device.

TIP

You can add multiple networks to 2go. They will be automatically remembered and connected to

when in range.

Hotspot mode

2go can create its own Wi-Fi hotspot. This acts as a replacement for Wi-Fi when no external network is

available.

1. In the Settings tab

, select Hotspot Mode.

2. Enable Wi-Fi on your control device and select 2go-XXXX to connect, where XXXXX is a number

unique to your 2go.

3. If available, select the “Use without internet” (IOS) or “Use this network as is” (Android) option on

your control device when connecting to 2go’s hotspot.

– On an iOS device, press “cancel” in the top right corner to reveal this option. Repeat this step if

necessary.

NOTE

Once your control device is successfully connected, these steps do not need to be repeated

when using Hotspot mode again.