User Manual

Chord Electronics
2go | User manual
10
8 Powering on 2go
To power on 2go:
1. Attach 2go to Hugo 2 (see chapter 4).
2. Press and hold the ‘config’ button
B
for 2 seconds.
or
3. Press and hold the power button of Hugo2 until the buttons start to glow. 2go will now automatically
switch on.
4. Wait approximately 15 seconds. The Network status LED
C
will remain Orange whilst booting up
(please wait). When fully booted the LED will then show the current network status (see section 2.2).
5. If you intend to play back audio via Hugo 2, you will need to select the USB input on the device. This
is denoted by a white LED,
TIP
We recommend using a 2go case to protect the connection between the two devices.
8.1 Powering o
To power o 2go:
1. Press and hold the ‘config’ button
B
for 5 seconds.
or
2. Press and hold the power button of Hugo 2. This switches both devices o.
3. Wait 20 seconds for 2go to power o