User Instructions

Step 2: Press the 'start' button on the remote control board to drive the
generator to run normally.
Step 3: Close the remote protection slide
Through the above steps, the generator can start normally
二、 enerator failure (when the generator is in normal operation)
Step 1: Remove the remote protection slide cover
Step 2: press the 'stop 'button on the remote control board, the generator starts
to stop. The motor can not start again during the shutdown.
Step 3: Close the remote protection slide.
The generator can be fully shut down by the above steps.
三、 Remote Control Learning (when the generator is fully down) :
Step 1: Remove the remote protection slide cover.
Step 2: hold the learning button on the generator until the learning green light
is always on.
Step 3: Release the study button and press any key (start or stop) on the remote
control. If the learning light flashes three times at this time, it means that the
learning is successful. If the learning is not successful, repeat this step
Battery replacement method:
1. Remove the remote control housing screws。
2. Remove old batteries and replace them with new ones。
3. Close the case and tighten the screws。
Points to note:
1. Never Slam the remote
2. The remote control should be placed in a dry place and it is forbidden to put
it into water
3. If the remote control is closer or dimmed, replace the battery
4. Forbid children to play