Product Info

Chongqing Jinou Science &Technology Development Co., Ltd.
http://www.oemblue.com/ [e-mail]
16
 Connection lasts
The duration of each time you connect and scan, that is the time you remain the
connection state. Duration = setting value × 625us
 Note: The duration of connection cannot be longer than the interval.
 Inquiry Interval
The interval of each time you inquire and scan, that is how often to allow queries.
Interval time = setting value × 625us
 Inquiry lasts
The duration of each time you Inquire and scan, that is the time you maintain the
Inquiring & scanning state. Duration = setting value × 625us
Note: The duration of Inquiring cannot exceed the interval of Inquiring.
 Sniff energy parameters
Sniff has four parameters: maximum, minimum, try, timeout. Parameter value =
set value × 625us. When all the four parameters are 0, the sniff energy saving is
forbidden, serial adapter run at full speed, the maximum data transmission
speed is the highest, but power is high, and it is recommended to use when
data is large. If allow to sniff energy, the serial adapter's power consumption will
be reduced, and it is recommended to allow to sniff energy when the data is small,
and it can reduce power consumption. Such as: Maximum = 800, minimum = 80,
try = 8, timeout = 8.
 Binding Bluetooth address
Inquiry the Bluetooth device address which matches with the Bluetooth module
 Inquiry
Inquiry the current settings of the serial adapter.
 Set
Set parameters to the serial adapter. However, it must be effective after the next
start.
 Default
Revert the serial adapter to the default setting. However, it must be effective after
the next start.
 Clear the address
Clear the address of the other Bluetooth device saved in the serial adapter. Once
the serial adapter establishes connection with a Bluetooth device, it will save its
address. At next communication, the Bluetooth module can only communicate
with this Bluetooth device and will not accept others’ addresses. You can clear the
Bluetooth address by this tool, so that you can communicate with other devices.
9.5 Set
After everything is ready, select the appropriate parameters from the connection setting
dialog, such as communication port and flow control mode, and click the Connect button
to establish a connection with the serial adapter.
When the connection is successful, the system will display the Inquired current setting
parameters of the serial adapter on the screen.
If users need to modify some of these parameters such as baud rate, you can select the
appropriate parameters, and after entering the appropriate values, click the Settings button
to set. After setting, you can execute the Inquire command to check if the parameter
settings are correct.
After setting parameters, you must press the toggle button to enter data mode, and then the