User's Manual
Table Of Contents
- Overview
- Parameters
- Description of Indicator Light and button
- Description of the authentication mode
- Parameter configuration
- Testing Command
- Parameter Setting Mode Indicate
- Inquire/Set Device Name
- Inquire Local Bluetooth Address
- Inquire/Set Remote Bluetooth Address
- Clear Remote Bluetooth Address
- Inquire Software Version
- Inquire/Set Device Role
- Set/Inquire Baud Rate
- Set/Inquire Flow Control Mode
- Set/Inquire Authentication Mode
- Set/Inquire Password
- Scan Around BLE Device
- Stop Scanning
- Inquire/Set Parameters of Connection-control
- Set/Inquire Scan Parameter
- Set/Inquire Broadcasting Interval
- Set/Inquire Transmit Power
- Set/Inquire BLE Data Communication Service UUID
- Set/Inquire BLE Data Communication Characteristic TXD UUID
- Default value: 0000 b351d6d8c7ecbdf0eab1bfc6bcbc
- This channel is used by the adapter to send data to the opposing BLE Bluetooth device.
- Set/Inquire BLE Data Communication Characteristic RXD UUID
- Default value: 0000 b352d6d8c7ecbdf0eab1bfc6bcbc
- This channel is used by the adapter to receive data from the other BLE Bluetooth device.
- Reset to Factory Default
- Restart the adapter
- OTA instructions
- Application examples
- Common Questions
2
Implementation
protocol
LL, SMP, L2CAP, ATT, GAP, GATT
Communication
interface
Standard RS232 five wire mode
Connector
DB9
Signal pin
RxD, TxD, RTS, CTS, GND
Energy saving
Auto Saving Mode to Support Low Power Mode
Maximum
transmission
rate note1
20Kbytes/Sec
Support Baud
Rate
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200, 230400bps
Power
consumption
Unconnected (slave device) 3.1mA
Unconnected (master device) 21mA
Connected (no data transmission) 3.6mA
Connected（data transmission）note2
9.8mA
Work
environment
Operating temperature
0℃～+70℃
Storage temperature
-10℃～+70℃
Humidity
5% ~ 90% no condensation
Size
99（L）×34（W）×17（H）mm
Note1: Here refer to that data - to - transmission rate between the two adapters, which relate to
connection parameters, such as different phone and adapter data, the rate may be different. If need
it up to maximum transmission rate, please set the baud rate to 230400.
Note1: The data transmission power consumption is the power consumption data continuously
transmitted at 9600 baud rate within the effective range of 10m.
III.
Description of Indicator Light and button
The BLE serial adapter has three LED lights to indicate the operating status of the device and a
mode switch button.