User's Manual
Table Of Contents
- Overview
- Parameters
- Description of Indicator Light and button
- Description of the authentication mode
- Parameter configuration
- Testing Command
- Parameter Setting Mode Indicate
- Inquire/Set Device Name
- Inquire Local Bluetooth Address
- Inquire/Set Remote Bluetooth Address
- Clear Remote Bluetooth Address
- Inquire Software Version
- Inquire/Set Device Role
- Set/Inquire Baud Rate
- Set/Inquire Flow Control Mode
- Set/Inquire Authentication Mode
- Set/Inquire Password
- Scan Around BLE Device
- Stop Scanning
- Inquire/Set Parameters of Connection-control
- Set/Inquire Scan Parameter
- Set/Inquire Broadcasting Interval
- Set/Inquire Transmit Power
- Set/Inquire BLE Data Communication Service UUID
- Set/Inquire BLE Data Communication Characteristic TXD UUID
- Default value: 0000 b351d6d8c7ecbdf0eab1bfc6bcbc
- This channel is used by the adapter to send data to the opposing BLE Bluetooth device.
- Set/Inquire BLE Data Communication Characteristic RXD UUID
- Default value: 0000 b352d6d8c7ecbdf0eab1bfc6bcbc
- This channel is used by the adapter to receive data from the other BLE Bluetooth device.
- Reset to Factory Default
- Restart the adapter
- OTA instructions
- Application examples
- Common Questions
6
VI.
Parameter configuration
In parameters setting mode, default parameter is 9600bps, 8-N–1, no CTS RTS flow control.
The following < CR >, < LF > in tables represent ASCII code of the "Enter" and “line feed”.
Every AT command send to the module needs to end up with the two codes. Otherwise the AT
commands can not be recognized. As for < >, it is use to convenient reading. In fact there is no < >
in command.