User Manual
10
Model: CN-2000 W
AC discharge
Press and hold the "AC start switch" for 3 seconds to turn on or off the AC software. The AC
ON icon of DC on the power LED screen will be on / display the current output voltage, then
the device can be used normally by arbitrarily inserting the load wire into AC output port 1 or
port 2, and the current power will be displayed on the display screen.
Note: please do not use loads that exceed the maximum output power of the equipment. The
maximum output power of the equipment is 2000 W. If the load exceeds 2000 W, the power
supply will enter the protection state and cannot be output, and the power supply can be used
normally after removing the excess load and restarting.
Charge the device
1. Insert the original standard adapter (25.5 V/8 A) into the "adapter charge port".
2. Insert the output port of in-vehicle cigarette lighter or solar panel with the specification of
18 V/(≥ 150 W) into the "vehicle charge / solar charge port" of the equipment
3. Insert the quick charger (25.2 V/15 A) into the "quick charge port". After arbitrarily
inserting the above three charge methods, the current charge power will be displayed on
the LCD display screen of the device, and the battery symbol % will also display the
battery charge power one by one.