Technical data

1313
1313
13
MKA4ST0UKPLAN5-7/Power Lan/ed.5/09-2003/UK
CHLORIDECHLORIDE
CHLORIDECHLORIDE
CHLORIDE
POWER PROTECTION
8.0 OPTIONS
8.1 Remote Control Module
The remote control module (Code 550016.001) is an accessory
that connects to the POWER LAN power control connector. It
allows remote start-up and shutdown of the UPS as well as
permitting remote monitoring of the following signals:
1 - MAINS STATUS LED
Green indicates that the UPS input voltage is within tolerances. Red indicates that mains power is out of
tolerance.
2 - BYPASS STATUS LED
Red indicates that the forced bypass is active. Green indicates normal UPS operation.
3 - BATTERY STATUS LED
Green indicates that the battery is charged.
Red indicates that the battery is low.
4 - OUTPUT STATUS LED
Green indicates that the UPS is providing output. Red indicates that there is no output.
5 - SHUTDOWN CONTROLS
Both of these buttons must be pressed simultaneously to shut down the UPS.
6 - STARTUP CONTROL
This button is pressed to start up the UPS.
7 - ALARM MUTE
Press this button to silence audible alarms generated by the remote power control unit.
An audible alarm is activated if any of the 4 status LED’s change from green to red.
8.2 International Voltages and Frequency Options
VOLTAGE:
Nominal voltage for standard UPS units is of 230 Vac and 115 Vac. Through the Monitoring and shutdown
software you can adjust output voltage in the range between 220 and 240 Vac, for 230 V.