User`s guide

APPENDIX B: ALARM DETAIL - UPS CONDITIONS THAT TRIGGER MANAGEUPS MESSAGING
SNMP
Alarm
ID
SNMP MIB OID Ref:
Log Entry &
Condition Email Subject
Probable Cause
Warning! Condition Codes
2 upsAlarmOnBattery Module On Battery UPS is running on battery power.
3 upsAlarmLowBattery Module Low Battery
Condition
Run time left is less than configured low battery alarm value.
9 upsAlarmOnBypass Module On Bypass The bypass is engaged by the UPS.
31 UpsAlarmGeneral
Warning
Module General Warning The UPS is indicating an unspecified fault condition
no trap Module Running On
Booster
The UPS is correcting a low input line condition without
using battery reserves
Informational Condition Codes
11 UpsAlarmOutputOff
AsRequested
Output Off As Requested Ups Output Has been Turned off via UPS Com port
command
12 UpsAlarmUpsOff
AsRequested
Module Off As Requested Ups Has been Turned off via UPS Com port command
14 upsAlarmUpsOutputOff Module Output Is Off Confirmation that the UPS output is off, but the UPS control
logic is still operating. This trap can only be sent if the
adapter is powered from a source other than UPS output.
15 upsAlarmUpsSystemOff Module System Is Off UPS output and control logic is off. Will likely never be seen.
21 upsAlarmAwaitingPower Module Awaiting Power UPS output is off and the UPS is waiting for input power to
be restored.
22 UpsAlarmShutdown
Pending
Shutdown Pending On
Module
A UPS shutdown timer has begun counting -- typically
means UPS monitoring software has request UPS output to
be turned off after a delay period.
23 UpsAlarmShutdown
Imminent
Shutdown Imminent On
Module
Output shutdown will occur in approximately 5 seconds.
24 UpsAlarmTestIn
Progress
Module Diagnostics Test in
Progress
A user requested UPS test has begun.
25 UpsAlarmBattery
Charging
Module Battery Charging The UPS Battery is recovering from a recent discharge
28 UpsAlarmSystemRestart
Pending
System Restart Pending The UPS is counting a user specified restart delay after AC
input is restired
30 UpsAlarmAutonomy
Calibration
Module Autonomy
Calibration
The UPS is discharging the battery an calibrating its run time
(autonomy) estimates