User`s guide

S
ECTION V: DEVICE SETTINGS
page, Section V 913-623 @Rev A Device Settings
2
Battery Capacity Designator:
Typically the number of battery packs attached to the UPS. (NOT A MIB OBJECT)
View the special help link for this parameter on the UPS Configuration page.
UPS Up Time:
The amount of time since the UPS was last started. (This value is returned as the
sysUpTime object in MIB-2).
Output Voltage
The measured UPS output voltage.
Output Source:
The source of the UPS output power. Under normal conditions this will be Utility. The
source may also be reported as Battery or Bypass.
Percent Load:
The percentage of the UPS capacity currently being supplied by the UPS.
Output Watts:
The measured UPS output power in Watts.
Input Line Disruptions:
The number of times the UPS has been on inverter due to input voltage being out of
tolerance.
Input Frequency:
The frequency measured on the UPS AC input.
Input Voltage:
The voltage measured at UPS AC input.
Min. Input Voltage Seen:
The lowest input voltage detected by the UPS since last reset.
(See Also
UPS Control to reset the stored minimum input voltage to the current input
voltage).
Max. Input Voltage Seen:
The highest input voltage detected by the UPS since last reset. (See Also UPS Control to
reset the stored maximum input voltage to the current input voltage).