User`s guide

S
ECTION IV: ADMINISTRATIVE SETTINGS
page, Section IV 913-623 @Rev A Administrative Settings
6
HARDWARE
RESET
There is a hardware RESET switch on the front
panel of the adapter. The RESET, depending on
the length it is depressed, performs one of three
functions.
1. If the RESET switch is depressed for
less than three seconds, it provides the
same function as rebooting the adapter.
2. If the RESET switch is depressed
anywhere from three to ten seconds,
the USERNAME and PASSWORD
revert back to the factory default.
3. If the RESET switch is depressed for
more than ten seconds, it reverts back
to the factory defaults.
The RESET Switch can be reached through the
access hole by using a paperclip or similar
object.
Note: Resetting the adapter with the RESET switch will clear all volatile object
values in the SNMP agent. This includes MIB-2 management objects:
upsUpTime, snmpInPackets, upsInputLineBads, upsAlarmsPresent,
etc.
If trap destinations (receivers) are configured, a Cold Start trap will be sent
when hardware reset is initiated.