User`s guide

SECTION III: SETTING SERVICE OPTIONS
Setting Service Options 913-623 @Rev A Section III, page
9
Network
Shutdown
Control
Services
Remote Shutdown Enabled:
Check to enable the Remote Shutdown Function.
Restart Delay
(applies to RCCMD only):
The amount of time to wait after power has been
restored to send the restart message to all IP
addresses with a restart port greater than 0. This
message will only be sent to those IP addresses that
have received the Shutdown message.
UPS Off Delay
(Available Only on UPS's with
Shutdown Capabilities):
The amount of time to wait after the last group is
executed before shutting the UPS off.
Network
Shutdown
Controller
Settings
Cancel UPS Shutdown if Utility
Power Returns After Execution
of Last Group
(Available Only on UPS's with
Shutdown Capabilities):
If this option is checked, the UPS shutdown will be
cancelled if power returns after the last group is
executed but before the UPS is turned off. (A restart
message will then be sent to all IP addresses
configured with an RCCMD restart port greater than 0
after the Restart Delay time.)
If this option is NOT checked, the UPS will be
shutdown regardless of the state of the input power. If
power was restored prior to UPS shutdown, then the
UPS will shut off and restart after a short delay.
(RCCMD Restart messages will not be sent to any IP
addresses in this scenario.