Cut Sheet

CM-22300 rev. 8,
CAX6 Series Compac
®
Semi-Recessed Head Thermoplastic
Emergency Unit with Xtest
Location of sensor for laser activation
of manual test via handheld remote laser
tester (this is an optional feature, specify
“LX” option)
SELF-TEST / DIAGNOSTIC
CHARGER
BATTERY
LAMPS
CHG-TEST
Xtest Status Indicator Panel
AC/Green Charger/Red Batt/Red Lamp/Red Status/Fault Action
On AC power is on/ok None
F Performing Test None
On F F F Lamp/Battery Disconnected or Charger Fault Check connections; if ok, replace circuit board
On F Charger fault Replace circuit board
On F Battery disconnected/fault Check connection or replace battery
On F Lamp disconnected/bad or remote disconnected Check connection then press manual test once to
determine bad lamp/replace lamp or check remote lamp.*
Fault Indications:
Four LED indicators provide visible indication of system status:
*If unit has remote capacity and remote cable is connected to charger board but not connected to
a remote load, then either connect remote load or disconnect cable from charger board.
On=Steady F=Flashing Blank=Off
dimensions
5-1/8"
(130.2mm)
12-5/8"
(320.7mm)
Depth: 3" (72.6mm)
performance
Meets Life Safety Code standard minimum illuminance of 0.1 FC and average
illuminance of 1.0 FC. Assumes open space with no obstructions, mounting
height: 8', ceiling height: 9', and reflectances: 80/50/20. Analysis based on
independently tested photometrics.
Note: All illustrations based on a 3' path of egress.
25'
Avg fc = 1.08
Min = 0.1
Max = 2.90
CAX6
3'
Test No.: 24401
CM-22300 03/13
© 2013 Koninklijke Philips Electronics N.V. All rights reserved.
Specifications are subject to change without notice.
Philips Lighting Company
200 Franklin Square Drive
Somerset, NJ 08873
Phone: [phone]
www.philips.com/luminaires
Philips Lighting Company
281 Hillmount Road
Markham ON, Canada L6C 2S3
Phone: [phone]
www.philips.com/luminaires