Installation Instructions

.
A10
Designed by BYYBUO,Assembled in PRC
FCC ID:2AXUI-A10
This device complies with Part 15 of the FCC Rules.
Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.changes or modifications not
expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interfer-ence in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communica-tions. However,there is no
guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception,which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician
for help.

CONTACT INFORMATION
[e-mail]
SAR tests are conducted using standard operating
positions accepted by the FCC with the device
transmitting at its highest certified power level in all
tested frequency bands, although
the SAR is determined at the highest certified power
level, the actual SAR level of the device while operating
can be well below the maximum value, in general, the
closer you are to a wireless antenna, the lower the power
output.
Before a new model device is a available for sale to the
public, it must be tested and certified to the FCC that it
does not exceed the exposure limit established by the
FCC, Tests for each device are performed in positions
and locations (e.g. at the ear and worn on the body)as
required by the FCC.
For body worn operation, this model device has been
tested and meets the FCC RF exposure guidelines when
used with an accessory designated for this product or
when used with an accessory that Contains no metal Non-
compliance with the above restrictions may result in
violation of RF exposure guidelines.