Installation manual

Iris Touch 400 Range Dialer Installation Manual10
7.2. Default alarm messages
The default SIA messages for each PIN are shown below:
Pin ‘Set’ message ‘Restore’ message Meaning
1 NBA01 NBR01 Burglary alarm/restore
2 NFA02 NFR02 Fire alarm/restore
3 NQA03 NQR03 Emergency alarm/restore
4 NOP04 NCL04 Open/close
5 NPA05 NPR05 Panic alarm/restore
6 NUA06 NUR06 User defined alarm/restore
7 NAT07 NAR07 Power fail/restore
8 NTA08 NTR08 Tamper/restore
9 NBA09 NBR09 Burglary alarm/restore
10 NFA10 NFR10 Fire alarm/restore
11 NQA11 NQR11 Emergency alarm/restore
12 NOP12 NCL12 Open/close
13 NPA13 NPR13 Panic alarm/restore
14 NUA14 NUR14 User defined alarm/restore
15 NAT15 NAR15 Power fail/restore
16 NTA16 NTR16 Tamper/restore
8. Relay outputs
The IRIS dialer has two relay outputs [9] that can be used in a number of ways:
• To indicate communications path failure.
• Activation by incoming SMS Message.
• Setting by the Monitoring Centre.
The relay contacts are normally open and closed when activated.
Wire to these contacts as required and define how they are to be used using the
configuration options on the Settings Menu. See Appendix A for more details.