Installation manual

Iris Touch 400 Range Dialer Installation Manual 5
4. Installing the IRIS Touch Dialer
Use the following procedure to install the IRIS Touch Dialer.
Note: For installations using PIN alarm inputs see the PIN alarms section for
additional information and for wiring to relay outputs see the Relay outputs
section.
Do not apply power to the dialer until indicated.
1. Decide where to mount the dialer and run the cables
Decide the best way to mount the dialer within the alarm panel enclosure
and the cables from the alarm panel to the dialer and the external
connections from the dialer.
2. Mount the dialer in the alarm panel enclosure
Secure the dialer within the enclosure using the self-adhesive feet.
3. Plug in the connectors
Connect the relevant cables to the PCB:
• Ethernet cable (cream) [1] (Ethernet / Ethernet & GPRS only)
• Dialer cable (grey) [2]
• Power cable (black) [3]
4. Install the antenna (GSM / Ethernet only)
Connect the antenna to the PCB [4].
5. Fit the SIM card (GSM / Ethernet & GPRS only)
Fit the SIM card [5].
Power must not be applied to the PCB while the SIM card is being
fitted or removed or it may be damaged.