Installation manual

IRIS Touch 400 Range Dialler Installation Manual V1.4
18
Conformance
The IRIS range of alarm diallers comply with the following European Directives:
1999/5/EC (Radio & Telecoms Terminal Equipment Directive).
2006/95/EC (Low Voltage Directive).
2004/108/EC (Electromagnetic Compatibility Directive).
Conformance to EN50131 and EN50136
The IRIS diallers are compatible with the requirements of European standards
EN50131-1 (Alarm Systems Intrusion and hold-up systems Part 1: System
Requirements) (dated 2006) and EN50136-1-1 (Alarm Systems Alarm
transmission systems and equipment) (January 1998 with Amendment 1 August
2001) as follows:
The IRIS diallers conform to Environmental Class II.
The IRIS diallers are compliant to ATS 6 compatible with Security Grade 4.
Safety
Care should be taken when interconnecting telecommunications equipment that
only like interfaces are interconnected to avoid safety hazards.
SELV:
SELV (Safety Extra-Low Voltage) is defined as a secondary circuit
which is so designed and protected that under normal and single fault
conditions the voltage between any two accessible parts does not
exceed a safe value (42.4V peak or 60V dc maximum).
The interfaces on the IRIS dialler have the following safety classifications:
Dialler Interface: SELV suitable for connection to the TNV interface of a
single line telecommunications equipment such as telephones, faxes, etc.
Data Interface: SELV suitable for connection to the SELV interface on a
data terminal such as a PC COM port.
Power Interface: SELV for connection to a DC supply.
Inputs and Outputs: SELV for connection to alarm output and input pins.
For conformance to the requirements of EN60950, the dialler must be powered
from a Limited Power Source as defined in EN60950. The output of the power
supply should be fused at 3.0A (slow blow).