Installation manual
IRIS Touch 400 Range Dialler Installation Manual V1.4
10
Note: If the ‘Alarm Override’ mode is selected, the IRIS Touch
Dialler replaces the phone number and the account number used by the
alarm dialler with the IP address of the monitoring centre and Account
Number entered during configuration, so there is no need to change any
settings on the alarm dialler. If this is not appropriate (e.g. if the alarm
dialler uses more than one account number) then the telephone number
dialed by the alarm dialler should be set to the IP address of the monitoring
centre in 12 digit format (e.g. 192.168.0.34 becomes 192168000034).
5. Carry out all the standard alarm signaling tests appropriate for the alarm
system.
6. Replace the cover on the alarm panel enclosure.
6. Post installation
If a fault should develop, then the ‘SYS’ LED indicator on the dialler will start
flashing and the display will show a system fault message.
This message can be touched to gain access to more information.
7. PIN alarms
The IRIS Touch series have PIN inputs [7] that can be used to generate alarm
messages. These can be:
Text messages via SMS. (GSM / Ethernet & GPRS only.)
SIA alarm messages over IP to the monitoring centre.
Contact ID (CID) alarm messages over IP to the monitoring centre.
Fast Format alarm messages over IP to the monitoring centre.
The messages for each PIN can be configured via the Settings Menu on the
touch screen display. See Appendix A for more details.