Installation manual

IRIS Touch 400 Range Dialler Installation Manual V1.4

4. Installing the IRIS Touch Dialler

Use the following procedure to install the IRIS Touch Dialler.

Note: For installations using PIN alarm inputs see the PIN alarms section for

additional information and for wiring to relay outputs see the Relay outputs

section.

Do not apply power to the dialler until indicated.

1. Decide where to mount the dialler and run the cables

Decide the best way to mount the dialler within the alarm panel enclosure

and the cables from the alarm panel to the dialler and the external

connections from the dialler.

2. Mount the dialler in the alarm panel enclosure

Secure the dialler within the enclosure using the self-adhesive feet.

3. Plug in the connectors

Connect the relevant cables to the PCB:

Ethernet cable (cream) [1] (Ethernet / Ethernet & GPRS only.)

Dialler cable (grey). [2]

Power cable (black). [3]

4. Install the antenna (GSM / Ethernet & GPRS only)

Connect the antenna to the PCB. [4]

5. Fit the SIM card (GSM / Ethernet & GPRS only)

Fit the SIM card. [5]

Power must not be applied to the PCB while the SIM card is being

fitted or removed or it may be damaged.